Capacity box (open systems) – HP StorageWorks XP Remote Web Console Software User Manual
Page 76
NOTE:
Do not add a space before or after the device name or an error will occur when you click Apply.
Also, do not use the following symbols: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, or %.
NOTE:
The device name is required to use SNMP Agent. Be sure to document the device name because
the settings are cleared if the SVP is replaced. For more information on SNMP, see “
•
Contact: Device support contact information, such as personnel and telephone numbers, where
you can inquire about the connected array. You can change the contact information in Modify
mode. This is a required field (maximum 180 alphanumeric characters). Do not use the following
symbols: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, or %. For more information on SNMP, see “
NOTE:
The contact name is required to use SNMP Agent. Be sure to document the contact name because
the settings are cleared if the SVP is replaced.
•
Device Location: Location of the connected array. The XP Remote Web Console user can change
the device location when in Modify mode. This is a required field (maximum 180 alphanumeric
characters). Do not use the following symbols: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, or %. For more
information on SNMP, see “
•
Firmware Version Main: Version of the microcode installed in the connected array.
•
Firmware Version SVP: Version of the XP Remote Web Console Java applet program installed in
the SVP of the connected array.
•
Firmware Version Server: Version of the RMI server installed in the SVP of the connected array.
•
Device View: Product name and visual image (picture) of the connected array.
Capacity Box (Open Systems)
LDEV information can be found on the lower left corner of the XP Remote Web Console main panel.
If you have logged in as a storage partition administrator, you will only be able to view the information
relative to the SLPR that you administer.
Performing XP Remote Web Console Operations
76