HP StorageWorks XP Remote Web Console Software - Manual (Page 110)

NOTE:
You cannot change this value from the XP Remote Web Console. Contact your HP account support
representative if you want to change the default setting.
• Maximum number of user entries: Sets the maximum number of user entries that can be registered
in the user account list of a array.
NOTE:
You cannot change this value from the XP Remote Web Console. Contact your HP account support
representative.
• Number of current user entries: Shows the number of user entries currently registered in the user
account list.
• Automatic distribution of the Java plug-in - Java Runtime Environment (JRE) is required to use XP
Remote Web Console. If a computer that is being used as an XP Remote Web Console does not
have JRE, the SVP can distribute and install the appropriate JRE automatically when the user logs
on to the SVP. The default is JRE1.4.2. Select JRE1.4.2 from the drop-down list for the Automatic
distribution of the Java plug-in parameter.
• RMI time-out period - If the user cannot access the SVP for a certain period of time because of a
network error, the RMI time-out logs the user off of the SVP. This has the following parameters:
• Specify 1 minute, 5 – 60 minutes in 5-minute increments, 70 to 120 minutes in 10-minute incre-
ments, or One day (24 hours). The default is 1 minute.
• Specify NO to disable this parameter.
NOTE:
If you specify NO as the value of the RMI time-out period, the user is not logged off
automatically when an error occurs. This might prevent that user from logging in again. This
setting is not recommended under ordinary circumstances.
• The value of the RMI time-out period must be greater than the value set for the smallest polling
period, either for checking the exclusive lock or for checking obstacles (see below for those
parameters). For example, specify a value of the RMI time-out period parameter to satisfy the
following condition: RMI time-out period > min [A, B], when A = Polling period for checking
exclusive lock, B = Polling period for checking obstacles, and min [A, B] indicates the minimum
value selected from A and B.
NOTE:
You cannot disable this parameter.
• RMI time-out for Modify mode: If a user is in Modify mode but does not make any changes that
access the RMI server for a specified period of time, Modify mode is released, and the View mode
is displayed.
• The default time period is 30 minutes. You can specify between 10 and 60 minutes in 10-minute
increments, or between 120 and 360 minutes in 60-minute increments.
Performing XP Remote Web Console Operations 110