Adding community ip addresses, Change community pop-up menu, Change community pane – HP StorageWorks XP Remote Web Console Software User Manual
Page 139: Adding community ip ad, Dresses, Adding community ip, Addresses, Figure 100, Figure
Figure 100 Change Community Pop-Up Menu
.
Figure 101 Change Community Pane
.
Adding Community IP Addresses
To add a community IP address:
1.
Log on to open the XP Remote Web Console main panel and then click Install (
). Click the
SNMP IP Security tab to display the SNMP IP Security panel (
).
2.
Select and right-click the desired community to display the Add Community popup menu (see
).
3.
Select the Add IP Address command. The Add IP Address panel is displayed (see
).
4.
In the IP Address box, enter a new IP address or select the existing IP address.
5.
Click OK. The new IP address is displayed in the Community & Trap box, but the change is not
yet implemented to the array.
6.
To apply the changes to the array, click Apply. Click OK. To cancel the changes, click Cancel.
XP Remote Web Console User Guide
139