Canon Color imageCLASS MF9280Cdn - Manual (Page 252)

Fax
5-31
Specifying Destinations
4
Enter a fax number using – , and
(numeric keys).
You can enter up to 40 characters for the fax
number.
Details of each item are shown below.
: Set the desired
destination.
: Delete the last number entered.
: Insert a pause of several seconds in
the fax number you are dialing. If you insert a
pause within the fax number, the letter
is
displayed between the numbers. If you insert
a pause at the end of the fax number, the
letter
appears.
When dialing an overseas number, insert a
pause after the country code and at the end
of the fax number. (See “Dialing an Overseas
Number (With Pauses),” on p. 5-22.)
: Select when you want to directly call
an extension line that is connected to a PBX
(Private Branch Exchange), which accepts only
tone signals. If you select and press
[OK], the letter appears.
: Send documents directly to
the recipient. Select , then press [OK]. If
you do not select direct sending mode,
memory sending mode is used. (See “Direct
Sending,” on p. 5-61.)
: Send a fax document manually or
use tone dialing. (See “Calling the Recipient
before Sending Fax Documents (Manual
Sending),” on p. 5-19, or “Switching
Temporarily to Tone Dialing,” on p. 5-21.)
–
–
–
–
–
–
You cannot insert a pause at the beginning of a
number.
If you enter a pause at the end of the number,
the pause is always 10 seconds long.
You can press (Clear) to clear your entry.
If in Send Function> in
under is set to , you
should enter the fax number again for
confirmation. Enter the fax number you
entered in step 4, then press [OK]. (See
“Security,” in the e-Manual.) –
–
–
–
5
Use [ ▼] , [▲] or (Scroll Wheel) to
select , then press [OK].
■ If you want to clear the specified
destination:
① Press the left Any key to select
Erase>.