Canon Color imageCLASS MF9280Cdn - Manual (Page 22)

Legal Notic
es
xx
Legal Notices
Users in Canada
Pre-Installation Requirements for Canon Facsimile
Equipment
A. Location
Supply a suitable table, cabinet, or desk for the
machine. See Chapter 14, “Appendix,” for specific
dimensions and weight.
B. Order Information
1. A single telephone line (touch-tone or rotary)
should be used.
2. Order a CA11A modular jack, which should
be installed by the telephone company. If the
CA11A jack is not present, installation cannot
occur.
3. Order a normal business line from your
telephone company’s business representative.
The line should be a regular voice grade line or
an equivalent one. Use one line per unit.
DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if
you communicate overseas
Canon recommends an individual line following industry
standards, i.e., 2,500 (touch-tone) or 500 (rotary/pulse dial)
telephones. A dedicated extension off a PBX (Private Branch
eXchange) unit without “Call Waiting” can be used with your
facsimile unit. Key telephone systems are not recommended
because they send nonstandard signals to individual telephones
for ringing and special codes, which may cause a facsimile error.
C. Power Requirements
The power outlet should be a three-prong
grounded receptacle (Single or Duplex). It should be
independent from copiers, heaters, air conditioners,
or any electric equipment that is thermostatically
controlled. The rated value is 115 volts and 15
amperes. The CA11A modular jack should be
relatively close to the power outlet to facilitate
installation.
Notice
This product meets the applicable Industry Canada
technical specifications.
The Ringer Equivalence Number is an indication
of the maximum number of devices allowed to be
connected to a telephone interface. The termination of
an interface may consist of any combination of devices
subject only to the requirement that the sum of the
RENs of all the devices does not exceed five.
The REN of this product is 1.0.
Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities
of the local telecommunications company. The
equipment must also be installed using an acceptable
method of connection. In some cases, the company’s
inside wiring associated with a single line individual
service may be extended by means of a certified
connector assembly (telephone extension cord). The
customer should be aware that compliance with the
above conditions may not prevent deterioration of
service in some situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated
by the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions,
may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that
the electrical ground connections of the power
utility, telephone lines, and internal metallic water
pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Users should not attempt to make such connections
themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
This equipment complies with the Canadian ICES-003 Class B
limits.
–
–
–
–
–
–