Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 79)

Conventional Fieldwork
69
computed and stored. The Foresight point will automatically
advance to the next available point name and the information
from the last shot is displayed on the screen.
d. You can see a graphical representation of the
previous shot by tapping the Map tab. See Page
24 for more information on the Map View.
Performing a Traverse Shot
6. The steps involved in performing a side shot are
nearly identical to performing a traverse shot. The
difference is you must specify if you plan to move the
total station to the current foresight point after the
shot is taken.
a. Tap the Input tab of the Traverse / Sideshot
screen. The Foresight point should now be
updated to 4.
b. Assuming that you are now aiming the total
station at a prism located over the foresight
point, tap Traverse . This would trigger the total
station to take a shot, compute coordinates for
the new point and store it. Since we are running
in Manual Mode, we will enter the shot data from
the keypad.
c. Enter the following data:
Angle Right: 45
Zenith: 90
Slope Dist: 50 and then tap .