Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 126)

User’s Manual – Conventional Mode
116
16. At anytime, you can view the current (non-reference)
DTM surface computed from the points staked so far
by tapping the
View… button.
The Store button will store the last point shot. The
Result card displays additional information about
the last stake point and the
Centerline card displays information related to the
last stake point in relation to the centerline, if selected earlier.
View the DTM
17. Tap View… to access the 3D View screen. While
staking points, you should periodically tap this
button to view what the current DTM surface looks
like. This is a useful quality assurance technique to
determine where additional points are needed.
Note: The View… button is only available when
Generate DTM with Staked Points is checked in the first
Stake DTM screen and at least three points are stored on
the non-reference DTM layer.
When the button is activated (darkened), dragging
within the 3D View will result in the image being rotated
to any angle. When the
button is activated, dragging
within the 3D View will pan the image.
The Volume button will display the total cut/fill volume difference
between the DTM surface being staked and a reference elevation
specified in the 3D View Settings screen, described next.