Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 364)

User’s Manual – GPS Mode
354
Start Survey – Connect to Rover
(Remote Base or Internet Base)
There are two workflows when you start a survey connecting to the
rover:
• The base broadcasting on a radio is already set and you wish
to start the rover with the remote base. This is the case
where there is more than one rover on a job site, or when you
exit and restart a job and you wish to restart the survey
without traveling back to the base.
• You are using the Internet to get corrections.
The workflow below is described for the NTRIP case. The remote
base on a radio is similar to the Set Rover and Setup Remote Base
procedure described above.
Connect to Internet
When Internet RTK is selected in the Job > Settings > Radio Settings
screen, we will always attempt to connect to the rover on the start of
the Start Survey Wizard. After connecting to the rover, we will dial
the Internet and attempt to decode the network type.
After the network type has been decoded, if it is a single base network
without an NTRIP logon protocol, we will go straight to Rover setup,
if it is a NTRIP network, we will go to the NTRIP Services page.
Note: You should not use this routine to connect to a VRS service
that does not use an NTRIP logon procedure. (This workflow is only
supported in the standard GPS module.)