Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 304)

User’s Manual – GPS Mode
294
Note: When doing continuous data collection, if your interval is
exceeded, but your acceptance criteria or RMS criteria are not met,
then you will be prompted to Accept the point anyway or to Wait for
the measurement to pass. If you choose to Wait, and then Cancel, you
will be prompted to Accept the point anyway or to Exit.
Occupy Control Point
Use this button to open the Control Points screen (Page 271), where
you can occupy a control point for the localization adjustment, or
occupy a check point to verify the current coordinate system solution.
Post Process
Use this button to open the RTK Rover Session screen. This screen is
used to start and stop point occupations in the post processing log file.
Use the RTK Rover Session screen when you wish to perform
additional occupations on the same point name, without effecting the
point’s coordinates in Survey Pro.