Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 113)

Road Layout
103
from segment field. (A positive offset value extends away from the
centerline.)
9. Once the correct station to stake is entered and the desired node
is selected, tap the Next > button to continue.
10. The next screen that opens is identical to the screens
used in point staking, since that is essentially what
is occurring at this point. If you are not familiar with
Point Staking, refer to Page 75.
11. Once you are satisfied with the rod location, tap
Store… and the prompt shown here will open where
the new point number and description can be
entered. Tap to store the stake point. If the Show
Results on OK checkbox is checked, tapping will
store the point and display detailed cut/fill results to
other nodes, which can then be written on the stake.
Note: If the Write Cut Sheet Data Only (No Store Point)
checkbox is checked in the Stakeout Settings screen, this
prompt will not appear, although the Results screen will
still appear if the Show Results on OK checkbox was never
un-checked from this prompt. (It is checked by default.)
12. Once the point is staked and stored, you will return to the screen
described above where a new node can be selected and staked or
the station to stake can be advanced by the station interval by
tapping the Next Sta button.