Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 370)

User’s Manual – GPS Mode
360
Collect Check Point Prompt
1. Select an existing job file point.
2. Designate if it is valid for horizontal, vertical, or
3D control.
3. Level the receiver over the point and tap Start
Control Point Occupation. This will open the Collect
Check Point screen, below, to monitor the
occupation.
Collect Check Point Screen
1. Examine the errors. Only the errors for the dimensions you
specify for this control point (2D/1D/3D) will be shown.
2. Tap Accept to finish the occupation. The control point is
created in the job file and the raw data is recorded.
This screen and the previous screen will exit, and
you will be at one of two places:
a. If you do not have one extra H or V point
for the localization check, you will be back
at the Check Points Status screen (Page
359).
b. If you have the required H and V points for
the check, the wizard will advance to the
Solve Localization and Detect Blunders
screen, below.