Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 268)

User’s Manual – GPS Mode
258
Start GPS Survey
The Start GPS Survey wizard is used to start any RTK survey. This
wizard will guide you through the steps required to choose a
coordinate system, set up your equipment, solve an adjustment, and
start collecting data or staking out points. The Start GPS Survey
wizard can be used for any RTK setup, regardless of your coordinate
system requirements, and your base and rover equipment
configuration.
The steps required to complete the Start GPS Survey wizard will
depend on the coordinate system and equipment you are using. All
the possible steps are described below.
Start GPS Survey – Choose One
Point Setup
One point setup is a special case of the Start GPS
Survey wizard. You can use one point setup mode only
when you have a brand new job with only one point.
When you use one point setup, Survey Pro will use
Ground - TDS Localization
mode, and automatically solve
the localization adjustment to give you ground level
coordinate system with the origin at your first point.
When you choose one point setup, there are no
additional steps required to solve your coordinate
system, all you have to do is complete base and rover
equipment setup and you are ready to survey.