Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 111)

Road Layout
101
33. We now need to repeat the above steps for the right side of the
road. Tap in the Right column to select that side of the
road and then tap the Add… button to open the Add Right Super
Elevation screen.
34. Enter the following data just as you did for the left
side of the road and then tap .
Start Station: 1+0
End Station: 1+25
Start Slope: -2
End Slope: -8 (notice this is a negative value)
Parabolic Transition Start: 0.0
Parabolic Transition End: 0.0
Hinge on: Center
35. With selected in the Right column, tap the
Add… button again to add the final super elevation.
36. Enter the following data to describe the second super
elevation on the right side of the road and then tap
.
Start Station: 2+0
End Station: 2+25
Start Slope: -8
End Slope: -2
Parabolic Transition Start: 0.0
Parabolic Transition End: 0.0
Hinge on: Center
37. This completes the definition for an entire road
including templates, widenings and super elevations.
To make sure there are no errors, tap Check…. You
should get a message stating success.
38. Tap to save the road.
You are now ready to stake the road in the field. Close any open
windows to return to the Main Menu.