Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 303)

GPS Module
293
Note: If you have Store GPS Raw Data set to + Bl,CV or + Bl,CV + Rx
Raw,
feature collection will not store base line records because there
is no discrete site occupation of each point. Therefore, the point name
does not need to be a valid Site Id.
3. Enter a Description.
Note: For continuous data collection (except Manual: multi
descriptions
), once the first point is accepted, all additional points will
be stored with the same description, layer, and attributes. When
using Manual: multi descriptions mode, you will be prompted for
description, layer, and attributes (if set) after every point.
4. Tap Feature. On the Feature Collection screen, select a Method.
An explanation of the selected method is displayed at the bottom
of the screen. See the Reference Manual for more information.
5. If you select a continuous method, or the Hold Still method, you
must specify an appropriate Interval.
6. Tap Start to begin measurements. The Occupy Data Points screen
displays the local coordinate.
7. When you are ready to begin continuous collection, tap Topo SS.
8. If you are using a continuous interval, Accept disappears and
points are stored when the interval is exceeded.
9. If your mode is Manual, tap Accept when you want to collect a
point. If your mode is Manual: multi descriptions, you will be
prompted for a description, layer, and attributes (if set) for each
point.
10. If you want to see a list of points stored so far, tap View Points.
11. If you wish to store points at any time during your continuous
interval, tap Topo SS.
12. Tap Done to end feature collection and return to the Data
Collection screen.