Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 274)

User’s Manual – GPS Mode
264
Base Setup Two - GET and SET
The Base Setup GET and SET screen is used when the geodetic
coordinate of the base reference position is not known. In this case,
you must GET an autonomous position from the GPS receiver, then
you can SET this as the reference position.
6. Tap GET Position From Rx to get an autonomous
position from the receiver. If you wish to get an
averaged position, enter a number in Average
position [n] epochs before GET
.
7. Check the results displayed in the edit boxes. If it
looks good, tap SET to start the base receiver
broadcasting this reference position and GPS
observations over the radio link, and to configure the
base reference position in Survey Pro.
Note: If you have post processing data collection turned
on, the receiver will now open a file (with the next
available default name), start recording GPS raw data,
and record the station and antenna information for this
static session.
Start GPS Survey – Rover Setup
The Start GPS Survey Rover Setup screen is used to setup an RTK
rover receiver, and to configure or check the base point reference
position in Survey Pro. Before proceeding to the Rover Setup screen,
you will be prompted to connect to an RTK rover or an NTRIP rover
receiver. Connecting to a rover receiver uses the same screen used for
the base receiver, described above on page 261. If you select an RTK
rover receiver, you will proceed directly to the Rover Setup screen. If
you choose an NTRIP rover, you will first be prompted to choose an
NTRIP service before you proceed to the Rover Setup screen