Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 320)

User’s Manual – GPS Mode
310
• Tap Set New Base>, and enter Chap as the Base Point.
• Tap SET to set the base and configure the base position in
Survey Pro. Tap Set Rover> to set the rover.
• The coordinate system is already solved, so you are ready to
collect data. The Data Collection screen opens.
11. Check points and add more GPS control points.
• Tap Control to open the Control Points screen. Select point 52
and tap Check. The results should be perfect.
12. Move the base to a point in the coordinate file not measured with
GPS.
• Tap close to close the Data Collection screen, and open Start
GPS Survey again. Tap Set New Base>
• Choose point 1 as the Base Point. Tap Next> and you are
prompted to compute the geodetic coordinates from the plane
coordinates using the current coordinate system. Tap OK.
Note: This action is equivalent to the TDS “Move Base” routine in the
DOS software.
• The geodetic coordinates for point 1 are computed. Tap SET
to set the base and configure base position in Survey Pro.
• Tap Set Rover> to finish equipment setup. Because the
coordinate system is already solved, the Data Collection
screen opens and you are ready to collect more points.
13. Check points.
Tap Control to open the Control Points screen. Select point CHAP
and tap Check. The results should be perfect.
14. Collect more data
You are now ready to add more points to the job.