Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 263)

253
GPS Module
Survey Pro can be sold with either the standard GPS module or the
Basic GPS module. This section outlines the procedures for using
Survey Pro with the GPS module. If using the Basic GPS module,
refer to Page 341.
The GPS module allows you to control a GPS receiver for both real
time and post processing data collection. This section describes how to
start a GPS survey and how to use GPS data collection and stake out.
In this section, you will learn:
¾ How to create a profile and manage GPS settings.
¾ How to start an RTK survey, or an RTK simultaneous with
post processing survey.
¾ How to select a projection mode to convert geodetic positions
(latitude, longitude, height) to your local coordinates
(Northing, Easting, Elevation).
¾ How to set up the RTK base receiver and configure the base
reference position.
¾ How to set up the RTK rover receiver.
¾ How to solve a horizontal and vertical localization coordinate
system adjustment, and when a coordinate system
adjustment is required.
¾ How to switch between grid and ground coordinates when
surveying on a selected mapping plane.
¾ How to collect data with GPS.
¾ How to stake out with GPS.
¾ How to use the Adjust with Projection wizard to update the
job file points when the coordinate system changes.
¾ How to use the Adjust with Projection wizard to adjust
selected points from one coordinate system to another.
¾ How to use the Projection Calculator to calculate convergence
and/or scale factors for a selected mapping plane zone.