Watlow EZ-ZONE RMH - Manual (Page 98)

Watlow EZ-ZONE ® RMH Module • 95 • Chapter 5 Factory Page
RM High Density Module • Factory Page
Display
Parameter Name
Description
Range Default
Modbus
Relative
Address
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Parameter
ID
Data
Type
& Read/
Write
[CUSt]
[FCty]
Custom Setup Menu
[`par]
[ Par] Custom Menu
Parameter 1 to 50
Select the parameters that
will appear in the Home Page
when using the RUI.
The Parameter 1 value will
appear in the upper display
of the Home Page. It can-
not be changed with the Up
and Down Keys in the Home
Page.
The Parameter 2 value will
appear in the lower display
in the Home Page. It can be
changed with the Up and
Down Keys, if the parameter
is a writable one.
Scroll through the other Home
Page parameters with the
Advance Key ‰ .
[nonE] None (61)
[`Pro] Process (75)
[`i;CA] Calibration Off-
set (1196)
[`C_F] Display Units
(156)
[USr;r] User Settings
Restore (227)
[`A;Lo] Alarm Low Set
Point (42)
[`A;hi] Alarm High Set
Point (78)
[`A;hy] Alarm Hysteresis
(97)
[stpt] Set Point ()
[aC;pu] Active Process
Value (25)
[aC;sp] Active Set Point
(72)
[``op] Open-Loop Set
Point (110)
[`aut] Autotune (158)
[`C;m] Control Mode
(159)
[`h;pr] Heat Power (160)
[`C;pr] Cool Power (161)
[``ti] Time Integral
(162)
[``td] Time Derivative
(163)
[``db] Dead Band (164)
[`h;pb] Heat Propor-
tional Band (166)
[`h;hy] Heat Hysteresis
(167)
[`C;pb] Cool Proportional
Band (169)
[`C;hy] Cool Hysteresis
(170)
[`r;rt] Ramp Rate (177)
[t;tun] TRU-TUNE+ En-
able (205)
[idle] Idle Set Point
(107)
CUSt] Custom Menu
(180)
Process
Limit
Status
- - - - - - - - - - - - 14005 uint
RWES
[`iid]
[ iid]
Custom Setup (1 to 50)
Instance ID
Select the parameters that will
appear in the Home Page.
1 to 24 - - - - - - - - - - - - - - - - 14003 uint
RWES
Note: Some values will be rounded off to fit in the four-character display . Full values can
be read with another interface .
If there is only one instance of a menu, no submenus will appear .
R: Read
W: Write
E: EE-
PROM
S: User
Set