Watlow EZ-ZONE RMH - Manual (Page 137)

Watlow EZ-ZONE ® RMH Module • 134 • Chapter 6 Features
Timer Function
[SFn;A] Source Function A (Timer Run) : None, Alarm, Compare, Counter, Digital
I/O, Profile Event Out A to H, Function Key, Logic, Special Function 1 to 4
, Timer, Variable
Output
[Fn] Function : Off, On Pulse, Delay, One Shot, Retentive
[SFn;b] Source Function B (Timer Reset) :
Digital I/O, Profile Event Out A to H, Function Key, Logic, Special Function
Output 1 to 4, Timer, Variable
None, Alarm, Compare, Counter,
[S2;A] Source A : 0 to 16 Zone
[S2;b] Source B : 0 to 16 Zone
[Si;A] Source A : 1 to 250 Instance
[Si;b] Source B : 1 to 250 Instance
[Su;A] Source A : Off, On Value
[Su;b] Source Value B : Off, On
[o;u] Output Value : Off, On
[E;t] Elapsed Time : 0.0 to 9,999.000 seconds
[ti] Time : 0 to 9,999 seconds
Timer
Overview
Instances - 24 per RMH
Fu
nctio
n
Sou
rce
Act
ive S
tate
A
Sou
rce
Act
ive S
tate
B
Source Function A
Source Instance A
Source Zone A
Source Error A
Source Function B
Source Instance B
Source Zone B
Source Error B
Tim
e
Act
ive L
eve
l
[tMr]
[`SEt]
Timer Menu
Setup Page
[SAS;A] Source Active State A (Timer Run) : High (rising), Low (falling)
[SAS;b] Source Active State B (Timer Reset) : High (rising), Low (falling)
[LEu] Active Level : High, Low
[tMr]
[oPEr]
Timer Menu
Operation Page
Output Value
Error
Source A Value
Source B Value
Elapsed Time
An error, when read, can indicate any of the following:
None, Open, Shorted, Measurement Error, Bad Cal Data,
Ambient Error, RTD Error, Fail, Math Error, Not Sourced,
Stale
Timer
Off
Fu
nctio
n
Sou
rce
Act
ive S
tate
A
Sou
rce
Act
ive S
tate
B
Source Function A
Source Instance A
Source Zone A
Source Error A
Source Function B
Source Instance B
Source Zone B
Source Error B
Tim
e
Act
ive L
eve
l
Output Value
Error
Source A Value
Source B Value
Elapsed Time
Output Value = OFF