Controlled Products Systems Group SWINGSMART DC 20 - Manual (Page 27)

Unpacking the Operator
Revision E Installation 1-5
U
NPACKING THE
O
PERATOR
Figure 1-4.
Prepare the gate operator for installation. See Figure 1-4.
1. Remove the top cap by unscrewing the knob.
2. Unfasten the side cover latches.
3. Remove the front cover.
4. Use a Phillips-head screwdriver to remove the two screws that secure the top of the rear cover. Set the
screws aside.
5. Remove the two wing nuts that secure the rear cover to the base plate and set the rear cover aside. Set the
wing nuts aside.
NOTE
Do not lose the Phillips-head screws or wing nuts as they are used to secure the rear cover when
the installation is complete.
6. Remove the four lag bolts and separate the operator from the shipping boards.
1
2
3
5
6
4
Front cover
Rear cover