Setting user account controls -28, Electrical controls -28, Electrical controls – Controlled Products Systems Group SWINGSMART DC 20 User Manual
Page 126

General Maintenance
6-28
SwingSmart DC Installation and Reference Manual
Revision E
Installing START Software, continued
NOTE
If the operating system on your laptop is VISTA or Windows 7, you must first disable the “User
Account Control Settings.” refer to the procedure in
, and then con-
tinue with step 9.
7. Follow the step-by-step instructions to complete the installation.
8. When the download is complete, log out of the HySecurity website. Shortcuts for the S.T.A.R.T. and
Smart DC Controller History Logs appear on your laptop’s desktop.
S
ETTING
U
SER
A
CCOUNT
C
ONTROLS
Because of the security settings inherent in VISTA and Windows 7, you need to disable the “user account controls”
in the operating system before uploading START software onto your laptop. Take the following steps:
In Windows 7:
Go to Start Menu -> Control Panel -> User Accounts -> User Account -> Change User Account Control Settings
“slide the slide bar to the lowest value (toward Never Notify), with description showing Never notify me -> Press
Ok -> Reboot Computer.
In Vista:
Go to the Start Menu type “msconfig” and press Enter -> In System Configuration select the tools tab -> Scroll
down till you find “Disable UAC” and single click it -> Press the Launch button -> Press the Apply button -> Press
OK -> Reboot Computer.
Electrical Controls
CAUTION
!
Before servicing, turn off all power switches.
No routine maintenance is needed for the electrical system or controls. If the environment is very sandy or
dusty, or has many insects, be certain to seal all holes in the electrical enclosure. Blow the dust out of the
electric panel with compressed air. Use
Table 6-1 "Smart DC Controller - Troubleshooting" on page 6-17
to assess
and fix error, alert, and fault codes. If it is necessary to call a distributor for assistance, be sure to have your
model and serial number ready. Other helpful information includes the name of the job, approximate date of
installation, and the service record of the operator, especially any work that has been done recently.