CTI Products MCN Server 8000 - Manual (Page 209)

Appendix B: Backup & Restore Procedures
209 68-12286-110
Restoring the MCN Server 8000 Software & IP Settings
1. Use the original or backup MCN Server 8000 software distribution media
2. Install the MCN Server 8000 software by following the step in Installing MCN Server Software
section starting on page 22 of this manual.
3. Select the Server installation option
4. When prompted for the Key File, use the original or backup Key File or Key File Media.
5. When prompted to enter IP parameters, enter the parameters saved in the MCN Server 8000 IP
Configuration Backup procedure.
Restoring the Custom System Configuration Files
1. Use the backup copy of the Custom MCN Server 8000 System Configuration Files
2. Using Windows Explorer, copy the backup files into a folder that has the following access
levels: Administrator Read & Write
User Read (and Write if desired)
3. If the files were previously Zipped, un-Zip them.
Restoring the HIB-IP Configuration
The Custom System Configuration Files restored above will have the configuration information for the
HIB-IP unit(s) (if used). If the HIB-IP needs to be restored (for example, if the HIB-IP unit is replaced),
follow this procedure:
1. Run MCN Config Server 8000 software.
2. Load the system that was restored above.
3. Program the HIB-IP Unit(s) as per the Programming HIB-IP and HIB-IP 8000 Units section
on page 86 of this manual.
Restoring the Client Software & IP Settings
1. Use the original or backup MCN Server 8000 software distribution media
2. Install the MCN Server 8000 software by following the step in section Installing MCN Server
Software starting on page 22 of this manual.
3. Select the Client installation option
4. When prompted to enter IP parameters, enter the parameters saved in the MCN Client IP
Configuration Backup procedure.