Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 16)

Installation Guideline
2-6 ADAM 4000 Series User’s Manual
2.2 Basic configuration and hook-up
Before placing a module in an existing network, the module should
be configured. Though all modules are initially configured at the
factory, it is recommended to check if the baud rate is set correctly
beforehand.
Default Factory Settings
Baud rate: 9600 Bit/sec.
Address: 01 (hexadecimal)
The basic hook-up for module configuration is shown below.
Figure 2-2 Basic Hook-up of ADAM Module to Host Switches