Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 107)

Command Set
4-4 ADAM 4000 Series User’s Manual
4.3 I/O Module Commands Search Table
ADAM-4011 Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, input range,baud
rate, data format, checksum
status, and/or integration time for a
specified analog input module
5-4
$AA2 Configuration Status Returns the configuration
parameters for the specified
analog input module 5-10
$AAF Read Firmware
Version
Return the firmware version code
from the specified analog input
module 5-12
$AAM Read Module Name Return the module name from the
specified analog input module 5-13
#AA Analog Data In Returns the input value from a
specified analog input module in
the currently configured data
format 5-14
$AA0 Span Calibration Calibrates an analog input module
to correct for gain errors 5-19
$AA1 Offset Calibration Calibrates an analog input module
to correct for offset errors 5-20
#** Synchronized
Sampling
Orders all analog input modules to
sample their input values and store
them in special registers 5-21
$AA4 Read Synchronized
Data
Returns the value that was stored
in the specified module's register
after the #** command 5-22
$AA3 CJC Status Returns the value of the CJC
sensor for a specified analog input
module 5-25
$AA9SNNNN CJC Offset
Calibration
Calibrates the CJC sensor for
offset errors 5-26
(Continued on following page)