Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 143)

Command Set
4-40 ADAM 4000 Series User’s Manual
ADAM-4080D Command Table
Command Syntax Command Name Command Description Page
No.
%AANNTTCCFF Configuration Sets the address, input mode,
baud rate, checksum status and/or
frequency gate time for a specified
counter/ frequency module 7-28
$AA2 Configuration Status Returns configuration parameters
from the specified
counter/frequency module 7-30
$AAF Read Firmware
Version
Return firmware version code from
the specified counter/frequency
module 7-31
$AAM Read Module Name Return the module name from the
specified counter/frequency
module 7-32
$AABS Set Input Signal
Mode Sets the input signal mode of the
specified counter/frequency
module to either non-isolated or
photo-isolated input signals 7-33
$AAB Read Input Signal
Mode Read the input signal mode of the
specified counter/frequency
module. 7-34
#AAN Read Counter or
Frequency Value Returns the value of counter 0 or
counter 1 from a specified counter/
frequency module in hex format 7-35
$AA8V Select LED Data
Origin Select whether LED will display
data from the counter/frequency
module directly or from the host
computer 7-36
$AA8 Read LED Data
Origin Returns the status of the LED Data
origin. Origin is either direct from
module or from host computer 7-37
$AA9(data) Send Data to LED The host computer sends data to
the addressed module to display
on its LED. This command is valid
only after selectting to display host
computer data ($AA8V) 7-38
(Continued on following page)