Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 139)

Command Set
4-36 ADAM 4000 Series User’s Manual
ADAM-4080 Command Table
Command Syntax Command Name Command Description Page
No.
%AANNTTCCFF Configuration Sets the address, input mode,
baud rate, checksum status and/or
frequency gate time for a specified
counter/ frequency module 7-28
$AA2 Configuration Status Returns configuration parameters
from the specified
counter/frequency module 7-30
$AAF Read Firmware
Version
Return firmware version code from
the specified counter/frequency
module 7-31
$AAM Read Module Name Return the module name from the
specified counter/frequency
module 7-32
$AABS Set Input Signal
Mode Sets the input signal mode of the
specified counter/frequency
module to either non-isolated or
photo-isolated input signals 7-33
$AAB Read Input Signal
Mode Read the input signal mode of the
specified counter/frequency
module. 7-34
#AAN Read Counter or
Frequency Value
Returns the value of counter 0 or
counter 1 from a specified counter/
frequency module in hex format 7-35
(Continued on following page)