Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 128)

Chapter
4
Chapter 4 Command Set 4-25
ADAM-4024 Command Table
Command Syntax Command Name Command Description Page
No.
%AANNTTCCFF Configuration Set the address, output range,
baud rate, data format, slew rate
and/or checksum status 6-19
#AACn(data) Analog Data Out Directs output data to a specified
module 6-20
#AASCn(data) Set Startup Data Set data As CHn StartUp Data
6-20
#AAECn(data) Set Emergency
Stop Set data As CHn Emergency
Stop Data 6-20
#** N/A Synchrous Sample IDI
6-20
$AA0Cn 4 mA Calibration Tells the module to store
parameters for 4 mA Calibration 6-20
$AA1Cn 20 mA Calibration Tells the module to store
parameters for 20 mA Calibration 6-20
$AA2 Configuration
Status
Read back Module status 6-20
$AA3Cn(number of
counts) Trim Calibration Trims specified module a number
of units up/down 6-20
$AA4 Start-up output
current/voltage
configuration
Stores a default output value in a
specified module. The output
value will take effect upon startup. 6-20
$AA5 Reset Status Read Back Reset Times After Last
$AA5 CMD And Clear This ounter 6-20
$AA6Cn Last Value
Readback
Returns either last value sent to
specified module by #AA
command, or start-up output
current/voltage 6-20
$AA7CnRxx
Set Output Type Set CHn Output Type 6-20
$AA8Cn Current Readback Returns measured value of the
current/voltage flowing through
current loop
6-21
$AAF Read Firmware
Version
Return the firmware version code
from the specified analog output
module 6-21
$AAM Read Module
Name
Return the module name from the
specified analog output module 6-21
(Continued on following page)