Advantech Data Acquisition Modules ADAM 4000 - Manual (Page 144)

Chapter
4
Chapter 4 Command Set 4-41
ADAM-4080D Command Table (Continued)
Command Syntax Command Name Command Description Page
No.
$AAAG Set Gate Mode Requests the specified counter/
frequency module to set its gate
mode to either high, low or disabled 7-40
$AAA Read Gate Mode Requests the specified counter/
frequency module to return the
status of its gate mode 7-41
$AA3N(data) Set Maximum
Counter Value
Sets the maximum value of counter
0 or counter 1 for the specified
counter/frequency module 7-42
$AA3N Read Maximum
Counter Value
Reads the maximum value of
counter 0 or counter 1 of the
specified counte/ frequency module 7-43
$AA5NS Start/Stop Counter The command orders the specified
counter/frequency module to start
or stop counting 7-44
$AA5N Read Counter
Start/Stop Status
The addressed counter frequency
module returns its status indicating
whether counting is enabled or
disabled 7-45
$AA6N Clear Counter The command clears the counter 0
or counter 1 of the specified
counter module 7-46
$AA7N Read Overflow Flag The addressed module returns the
status of the overflow flag of
counter 0 or counter 1 7-47
(Continued on following page)