GE Industrial Solutions Pulsar Plus Controller User Manual
Page 162

Pulsar Plus Controller Family
Issue 7 December 2011
162
GUI
Report GUI Compatibility
Syntax:
GUI
Description
This command is for internal use only. It reports an EasyView compatibility number. The
command response is: NE843GUI=1.0
ali
Special Internet Command
Syntax:
ali
Description
This command is for internal use only. It exists for EasyView compatibility purposes only and
does nothing.
Error Messages
While logging into the controller or while entering commands, you may encounter one or more of the
following error messages:
Error Message
Description
!-112, SYNTAX ERROR
Unrecognizable command was entered.
!-220, SECURITY
Super-user command was entered by someone with user status.
!-221, EXCESSIVE LOGIN ATTEMPTS
Too many attempts were made to login with an unrecognized
password.
!-223, INVALID PASSWORD
New password contains an illegal character.
!-224, NEW PASSWORD MISMATCH
First and second copy of new passwords don’t match
!-304, INVALID PARAMETER
An attempt was made to change a parameter to an illegal value.
!-319, INVALID ATTRIBUTE
An invalid object id was specified in the command or, a command
referred to an attribute that doesn’t support it.
!-320, INVALID OBJECT
An invalid object id was specified in the command
!328, FEATURE DISABLED
An attempt was made to initiate a feature that is disabled.
!335, COULD NOT EXECUTE
Command could not execute because of active alarms or a conflicting
operation.