Rainbow Electronics GM862-QUAD-PY - Manual (Page 98)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 98 of 434
+CCWA - Call Waiting SELINT 0 / 1
Parameters:
- enables/disables the presentation of an unsolicited result code:
0 - disable
1 - enable
- enables/disables or queries the service at network level:
0 - disable
1 - enable
2 - query status
- is a sum of integers each representing a class of information
which the command refers to; default is 7 (voice + data + fax)
1 - voice (telephony)
2 - data
4 - fax (facsimile services)
8 - short message service
16 - data circuit sync
32 - data circuit async
64 - dedicated packet access
128 - dedicated PAD access
Note: the response to the query command is in the format:
+CCWA: ,[
+CCWA: ,[ … ]]
where
represents the status of the service:
0 - inactive
1 - active
n> - same as
Note: the unsolicited result code enabled by parameter is in the
format:
+CCWA: ,,,,
where
- string type phone number of calling address in format
specified by
- type of address in integer format
- see before
- string type; alphanumeric representation of
corresponding to the entry found in phonebook; used character
set should be the one selected with +CSCS.
0 - CLI valid
1 - CLI has been withheld by the originator
2 - CLI is not available due to interworking problems or limitations of