Rainbow Electronics GM862-QUAD-PY - Manual (Page 384)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 384 of 434
#CSURVC - Network Survey (Numeric Format) SELINT 0 / 1
14,8
Network survey ended
OK
Note The command is executed within max. 2 minute.
The information provided by #CSURVC is the same as that provided by
#CSURV. The difference is that the output of #CSURVC is in numeric
format only.
#CSURVC - Network Survey (Numeric Format)
SELINT 2
AT#CSURVC[=
[,]]
AT*CSURVC[=
[=,]]
(both syntax are
possible; the second
syntax is maintained
only for backward
compatibility and will
not be present in
future versions) Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting from
channel to channel . Issuing AT#CSURVC, a full band scan
is performed.
Parameters:
- starting channel
- ending channel
After issuing the command the device responds with the string:
Network survey started…
and, after a while, a list of informations, one for each received carrier, is
reported, each of them in the format:
(For BCCH-Carrier)
,,,,,,,,
,[, ..[ ]]
[,[, ..[]][, [,,,,
,,,,,,,
,]]]
where:
- C0 carrier assigned radio channel (BCCH - Broadcast Control
Channel)
- base station identification code; if #CSURVF last setting is 0,
is a decimal number, else it is a 2-digits octal number
- decimal number; it is the receiption level (in dBm)
- decimal number; it is the bit error rate (in %)
- hexadecimal 3-digits number; it is the mobile country code
- hexadecimal 2-digits number; it is the mobile network code
- location area code; if #CSURVF last setting is 0, is a decimal