Rainbow Electronics GM862-QUAD-PY User Manual

Page 192

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 192 of 434

+CNMI - New Message Indications To Terminal Equipment

SELINT 2

=
1

is full, indications can be buffered in some other place or the
oldest indications may be discarded and replaced with the new
received indications.

1 - Discard indication and reject new received message unsolicited

result codes when TA-TE link is reserved, otherwise forward
them directly to the TE.

2 - Buffer unsolicited result codes in the TA in case the DTE is busy

and flush them to the TE after reservation. Otherwise forward
them directly to the TE.

3 - if is set to 1 an indication via 100 ms break is issued when

a SMS is received while the module is in GPRS online mode. It
enables the hardware ring line for 1 s. too.

- result code indication reporting for SMS-DELIVER
0 - No SMS-DELIVER indications are routed to the TE and

messages are stored in SIM.

1 - If SMS-DELIVER is stored into ME/TA, indication of the memory

location is routed to the TE using the following unsolicited result
code:
+CMTI: ,
where:
- memory storage where the new message is stored

(see +CPMS)

- location on the memory where SMS is stored.

2 - SMS-DELIVERs (except class 2 messages and messages in the

“store” message waiting indication group) are routed directly to
the TE using the following unsolicited result code:

(PDU Mode)

+CMT: ,
where:
- alphanumeric representation of originator/destination

number corresponding to the entry found in MT
phonebook; used character set should be the one
selected with command +CSCS.

- PDU length
- PDU message

(TEXT Mode)

+CMT:,,[,,,,,
,,] (the information
written in italics will be present depending on +CSDH last setting)
where:
- originating address, string type converted in the currently

selected character set (see +CSCS)

- alphanumeric representation of ; used character

set should be the one selected with command +CSCS.

- arrival time of the message to the SC