Rainbow Electronics GM862-QUAD-PY - Manual (Page 159)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 159 of 434
+CGQMIN - Quality Of Service Profile (Minimum Acceptable) SELINT 0 / 1
OK
Reference GSM 07.07; GSM 03.60
+CGQMIN - Quality Of Service Profile (Minimum Acceptable)
SELINT 2
AT+CGQMIN=
[
[,
[,
[,
[,
[,]]]]]] Set command allows to specify a minimum acceptable profile which is
checked by the terminal against the negotiated profile returned in the
Activate PDP Context Accept message.
Parameters:
- PDP context identification (see +CGDCONT command).
- precedence class
- delay class
- reliability class
- peak throughput class
- mean throughput class
If a value is omitted for a particular class then this class is not checked.
Note: a special form of the Set command, +CGQMIN= causes the
requested profile for context number to become undefined.
AT+CGQMIN? Read command returns the current settings for each defined context in the
format:
+CGQMIN: ,,,,,
[+CGQMIN: ,,
,,,[…]]
If no PDP context has been defined, it has no effect and OK result code is
returned.
AT+CGQMIN=? Test command returns as a compound value the type of the current PDP
context and the supported values for the subparameters in the format:
+CGQMIN: ,(list of supported s),
(list of supported s),(list of supported s),
(list of supported s),(list of supported s)
Note: only the “IP” PDP_Type is currently supported.
Example AT+CGQMIN=1,0,0,3,0,0
OK
AT+CGQMIN?
+CGQMIN: 1,0,0,5,0,0
OK
AT+CGQMIN=?
+CGQMIN: “IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK