Rainbow Electronics GM862-QUAD-PY - Manual (Page 182)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 182 of 434
+CSCB -Select Cell Broadcast Message Types SELINT 0 / 1
[
[,
[,]]]]
received by the device.
Parameter:
0 - the message types defined by and are accepted
(factory default)
1 - the message types defined by and are rejected
- Message Identifiers, string type: all different possible
combinations of the CBM message identifiers; default is empty
string (“”).
- Data Coding Schemes, string type: all different possible
combinations of CBM data coding schemes; default is empty string
(“”).
Note: the current settings are stored through +CSAS
Note: issuing AT+CSCB is the same as issuing the Read command.
Note: issuing AT+CSCB= is the same as issuing the command
AT+CSCB=0.
AT+CSCB? Read command reports the current value of parameters ,
and .
AT+CSCB=? Test command returns the range of values for parameter .
Example AT+CSCB?
+CSCB: 1,"",""
OK
(all CBMs are accepted, none is rejected)
AT+CSCB=0,"0,1,300-315,450","0-3"
OK
Reference GSM 07.05, GSM 03.41, GSM 03.38.
CSCB -Select Cell Broadcast Message Types
SELINT 2
AT+CSCB=
[[,
[,]]] Set command selects which types of Cell Broadcast Messages are to be
received by the device.
Parameters:
0 - the message types defined by and are accepted
(factory default)
1 - the message types defined by and are rejected
- Message Identifiers, string type: all different possible
combinations of the CBM message identifiers; default is empty
string (“”).
- Data Coding Schemes, string type: all different possible
combinations of CBM data coding schemes; default is empty string
(“”).