Rainbow Electronics GM862-QUAD-PY - Manual (Page 200)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 200 of 434
+CMGL - List Messages SELINT 2
(#SMSMODE=1)
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
AT+CMGL
[=] Execution command reports the list of all the messages with status
value stored into message storage ( is the
message storage for read and delete SMs as last settings of
command +CPMS).
The parameter type and the command output depend on the last
settings of command +CMGF (message format to be used)
(PDU Mode)
Parameter:
0 - new message
1 - read message
2 - stored message not yet sent
3 - stored message already sent
4 - all messages.
If there is at least one message to be listed the representation format
is:
+CMGL:
,,,[
+CMGL: ,,,[...]]
where:
- message position in the memory storage list.
- status of the message
- string type alphanumeric representation of or ,
corresponding to an entry found in the phonebook; used
character set is the one selected with command +CSCS.
- length of the PDU in bytes
- message in PDU format according to GSM 3.40
(Text Mode)
Parameter:
"REC UNREAD" - new message
"REC READ" - read message
"STO UNSENT" - stored message not yet sent
"STO SENT" - stored message already sent
"ALL" - all messages.
The representation format for stored messages (either sent or unsent)
or received messages (either read or unread, not message delivery