Rainbow Electronics GM862-QUAD-PY - Manual (Page 382)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 382 of 434
#CSURVC - Network Survey (Numeric Format) SELINT 0 / 1
,[, ..[ ]]
[,[, ..[]][, [,,,,
,,,,,,,
,]]]
where:
- C0 carrier assigned radio channel (BCCH - Broadcast Control
Channel)
- base station identification code
- receiption level (in dBm)
- bit error rate (in %)
- mobile country code
- mobile network code
- location area code
- cell identifier
- cell status
..0 - C0 is a suitable cell (CELL_SUITABLE).
1 - the cell is low priority based on the received system information
(CELL_LOW_PRIORITY).
2 - the cell is forbidden (CELL_FORBIDDEN).
3 - the cell is barred based on the received system information
(CELL_BARRED).
4 - the cell is low (CELL_LOW_LEVEL).
5 - none of the above e.g. exclusion timer running, no BCCH
available…etc.. (CELL_OTHER).
- number of valid channels in the Cell Channel Description
n> - arfcn of a valid channel in the Cell Channel Description (n is in
the range 1..)
- number of valid channels in the BCCH Allocation list;
the output of this information for non-serving cells depends on
last #CSURVEXT setting:
1. if #CSURVEXT=0 this information is displayed only for
serving cell
2. if #CSURVEXT=1 or 2 this information is displayed also for
every valid scanned BCCH carrier.
n> - arfcn of a valid channel in the BA list (n is in the range
1..); the output of this information for non-
serving cells depends on last #CSURVEXT setting:
1. if #CSURVEXT=0 this information is displayed only for
serving cell
2. if #CSURVEXT=1 or 2 this information is displayed also for
every valid scanned BCCH carrier.
(The following informations will be printed only if GPRS is supported in the
cell)
> - packet broadcast control channel
0 - pbcch not activated on the cell