Rainbow Electronics GM862-QUAD-PY - Manual (Page 297)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 297 of 434
#PSET - Audio Profile Setting SELINT 2
[,
]]]]]]]]]]]]]]]] - noise reduction weighting factor (band 300-500Hz)
- noise reduction weighting factor (band 500-4000Hz)
- AGC Additional attenuation
- AGC minimal attenuation
- AGC maximal attenuation
AT#PSET? Read command returns the parameters for the active profile in the format:
#PSET:,,,,ter_length>,,,,,
,,
It is not allowed if active audio profile is 0.
AT#PSET=? Test command returns the supported range of values for the audio
parameters.
3.5.7.1.66 Handsfree Automatic Gain Control - #SHFAGC
#SHFAGC - Handsfree Automatic Gain Control SELINT 2
AT# SHFAGC =
Set command enables/disables the automatic gain control function on audio
handsfree input.
Parameter:
0 - disables automatic gain control for handsfree mode (default)
1 - enables automatic gain control for handsfree mode
Note: This parameter is saved in NVM issuing AT&W command.
AT# SHFAGC? Read command reports whether the automatic gain control function on
audio handsfree input is currently enabled or not, in the format:
#SHFAGC:
AT# SHFAGC =? Test command returns the supported range of values of parameter
.
3.5.7.1.67 Handsfree Noise Reduction - #SHFNR
# SHFNR - Handsfree Noise Reduction SELINT 2
AT#SHFNR =
Set command enables/disables the noise reduction function on audio
handsfree input.
Parameter:
0 - disables noise reduction for handsfree mode (default)
1 - enables noise reduction for handsfree mode
Note: This parameter is saved in NVM issuing AT&W command.