Rainbow Electronics GM862-QUAD-PY - Manual (Page 176)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 176 of 434
+CSMP - Set Text Mode Parameters SELINT 0 / 1
[
[,
[,
[,]]]]] and sending SMs when the text mode is used (+CMGF=1)
Parameters:
- depending on the command or result code:
first octet of GSM 03.40 SMS-DELIVER, SMS-SUBMIT (default 17),
SMS-STATUS-REPORT, or SMS-COMMAND (default 2) in integer
format.
- depending on SMS-SUBMIT setting:
GSM 03.40 TP-Validity-Period either in integer format (default 167) or
in quoted time-string format
- GSM 03.40 TP-Protocol-Identifier in integer format.
- depending on the command or result code:
GSM 03.38 SMS Data Coding Scheme (default 0), or Cell
Broadcast Data Coding Scheme
Note: the current settings are stored through +CSAS
Note: issuing AT+CSMP is the same as issuing the Read command.
Note: issuing AT+CSMP= is the same as issuing the command
AT+CSMP=0.
AT+CSMP? Read command reports the current setting in the format:
+CSMP: < fo>,,,
AT+CSMP=? Test command reports the supported range of values for , ,
and parameters.
Example Set the parameters for an outgoing message with 24 hours
of validity period and default properties:
AT+CSMP=17,167,0,0
OK
Reference GSM 07.05; GSM 03.40; GSM 03.38
+CSMP - Set Text Mode Parameters
SELINT 2
Note: the behaviour of command +CPMS differs depending on whether or not the improved SMS
commands operation mode has been enabled (see #SMSMODE)
(#SMSMODE=0)
#
S
M
S
M
O
D
E
AT+CSMP=
[
[,
[,
[,]]]] Set command is used to select values for additional parameters for
storing and sending SMs when the text mode is used (AT+CMGF=1)
Parameters:
- first octet of GSM 03.40 SMS-SUBMIT in integer format
(default 17, i.e. SMS-SUBMIT with validity period in relative
format). As first octet of a PDU has the following bit field
description (we’ll refer to