Rainbow Electronics GM862-QUAD-PY - Manual (Page 140)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 140 of 434
+CRSL - Ringer Sound Level SELINT 0
1 - low
2 - middle
3 - high
4 - progressive
Note: if parameter is omitted then the behaviour of Set command is the
same as Read command
AT+CRSL? Read command reports the current setting of the call ringer in the
format:
+CRSL:
AT+CRSL=? Test command reports supported values as compound value.
For compatibility with previous versions, Test command returns
+CRSL: (0-3)
An enhanced version of Test command has been defined: AT+CRSL=??,
that provides the complete range of values for .
AT+CRSL=?? Enhanced Test command returns the complete range of supported values
for the parameter :
+CRSL: (0-4)
Reference GSM 07.07
+CRSL - Ringer Sound Level
SELINT 1
AT+CRSL[=
] Set command is used to select the incoming call ringer sound level of the
device.
Parameter:
- ringer sound level
0 - Off
1 - low
2 - middle
3 - high
4 - progressive
Note: if parameter is omitted then the behaviour of Set command is the
same as Read command
AT+CRSL? Read command reports the current setting of the call ringer in the
format:
+CRSL:
AT+CRSL=? Test command reports supported values as compound value, in the
format:
+CRSL: (0-4)