Rainbow Electronics GM862-QUAD-PY - Manual (Page 379)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 379 of 434
#CSURV - Network Survey SELINT 2
where:
- C0 carrier assigned radio channel (BCCH - Broadcast Control
Channel)
- base station identification code; if #CSURVF last setting is 0,
is a decimal number, else it is a 2-digits octal number
- decimal number; it is the receiption level (in dBm)
- decimal number; it is the bit error rate (in %)
- hexadecimal 3-digits number; it is the mobile country code
- hexadecimal 2-digits number; it is the mobile network code
- location area code; if #CSURVF last setting is 0, is a decimal
number, else it is a 4-digits hexadecimal number
- cell identifier; if #CSURVF last setting is 0, is a decimal
number, else it is a 4-digits hexadecimal number
- string type; it is the cell status
..CELL_SUITABLE - C0 is a suitable cell.
CELL_LOW_PRIORITY - the cell is low priority based on the received
system information.
CELL_FORBIDDEN - the cell is forbidden.
CELL_BARRED - the cell is barred based on the received system
information.
CELL_LOW_LEVEL - the cell is low.
CELL_OTHER - none of the above e.g. exclusion timer running, no
BCCH available…etc.
- number of valid channels in the Cell Channel Description
n> - arfcn of a valid channel in the Cell Channel Description (n is in
the range 1..)
- decimal number; it is the number of valid channels in the
Cell Channel Description
n> - decimal number; it is the arfcn of a valid channel in the Cell
Channel Description (n is in the range 1..)
- decimal number; it is the number of valid channels in
the BCCH Allocation list; the output of this information for non-
serving cells depends on last #CSURVEXT setting:
2. if #CSURVEXT=0 this information is displayed only for
serving cell
3. if #CSURVEXT=1 or 2 this information is displayed also for
every valid scanned BCCH carrier.
n> - decimal number; it is the arfcn of a valid channel in the BA list (n
is in the range 1..); the output of this
information for non-serving cells depends on last #CSURVEXT
setting:
2. if #CSURVEXT=0 this information is displayed only for
serving cell
3. if #CSURVEXT=1 or 2 this information is displayed also for
every valid scanned BCCH carrier.