Rainbow Electronics GM862-QUAD-PY - Manual (Page 164)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 164 of 434
+CGPADDR - Show PDP Address SELINT 0 / 1
referred to by ; if no address is available the empty
string (“”) is represented as
AT+CGPADDR=? Test command returns a list of defined s.
Example AT#GPRS=1
+IP: xxx.yyy.zzz.www
OK
AT+CGPADDR=1
+CGPADDR: 1,”xxx.yyy.zzz.www”
OK
AT+CGPADDR=?
+CGPADDR: (1)
OK
Reference GSM 07.07
+CGPADDR - Show PDP Address
SELINT 2
AT+CGPADDR=
[[,
[,…]]] Execution command returns a list of PDP addresses for the specified
context identifiers in the format:
+CGPADDR: ,[+CGPADDR: ,
[…]]
Parameters:
- a numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command). If no is specified, the
addresses for all defined contexts are returned.
- a string that identifies the terminal in the address space
applicable to the PDP. The address may be static or
dynamic. For a static address, it will be the one set by the
+CGDCONT command when the context was defined. For a
dynamic address it will be the one assigned during the last
PDP context activation that used the context definition
referred to by ; if no address is available the empty
string (“”) is represented as
AT+CGPADDR=? Test command returns a list of defined s.
Example AT#GPRS=1
+IP: xxx.yyy.zzz.www
OK
AT+CGPADDR=1
+CGPADDR: 1,”xxx.yyy.zzz.www”
OK