Rainbow Electronics GM862-QUAD-PY - Manual (Page 213)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 213 of 434
@CMGR - Read Message Improved SELINT 0
- Destination address, string type represented in the currently
selected character set (see +CSCS)
- Service Centre number
,, - type of number ,,
129 - number in national format
145 - number in international format (contains the "+")
- text length
- message text
Note: the command differs from the +CMGR because after the message
or a is put before the OK result code.
Note: in both cases if status of the message is 'received unread', status in
the storage changes to 'received read'.
Note: an error result code is sent on empty record .
AT@CMGR=? Test command has no effect; the answer is OK
Reference GSM 07.05
@CMGR - Read Message Improved
SELINT 1
AT@CMGR=
Execution command reports the message with location value from
message storage ( is the message storage for read and
delete SMs as last settings of command +CPMS).
Parameter:
- message index.
The output depends on the last settings of command +CMGF (message
format to be used)
(PDU Mode)
The output has the following format:
@CMGR: ,
where
- status of the message
0 - new message
1 - read message
2 - stored message not yet sent
3 - stored message already sent
- length of the PDU in bytes.
- message in PDU format according to GSM 3.40.
The status of the message and entire message data unit is
returned.
(Text Mode)