Rainbow Electronics GM862-QUAD-PY - Manual (Page 273)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 273 of 434
#MSCLASS - Multislot Class Control SELINT 2
Note: the range for former GM862 family products is 1..8,
excluding class 7.
AT#MSCLASS? Read command reports the current value of the multislot class in the
format:
#MSCLASS:
AT#MSCLASS=? Test command reports the range of available values for both parameters
and .
3.5.7.1.43 Cell Monitor - #MONI
#MONI - Cell Monitor SELINT 0 / 1
AT#MONI[=
[]] #MONI is both a set and an execution command.
Set command sets one cell out of seven, in a neighbour of the serving cell
including it, from which extract GSM-related information.
Parameter:
0..6 - it is the ordinal number of a cell, in a neighbour of the serving cell
(default 0, serving cell).
7 - it is a special request to obtain GSM-related informations from the
whole set of seven cells in the neighbour of the serving cell.
Note: issuing AT#MONI is the same as issuing the Read command.
Note: issuing AT#MONI= is the same as issuing the command
AT#MONI=0.
AT#MONI? Execution command reports GSM-related informations for selected cell
and dedicated channel (if exists).
a) When extracting data for the serving cell and the network name is
known the format is:
#MONI: BSIC: RxQual: LAC:
Id: ARFCN: PWR: dBm TA:
b) When the network name is unknown, the format is:
#MONI: Cc: Nc: BSIC: RxQual: LAC:
Id: ARFCN: PWR: dBm TA:
c) When extracting data for an adjacent cell, the format is:
#MONI: Adj Cell [LAC: Id:] ARFCN:
PWR: dBm
where:
- name of network operator