Rainbow Electronics GM862-QUAD-PY User Manual

Page 395

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 395 of 434

#STIA - SIM Tookit Interface Activation

SELINT 2

AT#STIA=
[
[,]]

Set command is used to activate the SAT sending of unsolicited indications
when a proactive command is received from SIM.

Parameters:

0 - disable SAT (no required, if given will be ignored)
1 - enable SAT without unsolicited indication #STN
2 - enable SAT and extended unsolicited indication #STN (see #STGI)
3 - enable SAT and reduced unsolicited indication #STN (see #STGI)
- time-out for user responses
1..255 - time-out in minutes (default 10). Any ongoing (but unanswered)

proactive command will be aborted automatically after
minutes. In this case, the terminal response is either “ME currently
unable to process command”, or if applicable, “No response from
user”. In addition an unsolicited indication will be sent to the external
application:

#STN:

where:
is defined as + terminate
offset; the terminate offset equals 100.

Note: every time the SIM application issues a proactive command that
requires user interaction an unsolicited code will be sent, if enabled with
#STIA command, as follows:

• if parameter of #STIA command has been set to 3 (reduced

unsolicited indication) an unsolicited indication will be sent, indicating
the type of proactive command issued by the SIM:

#STN:

• if parameter of #STIA command has been set to 2 (extended

unsolicited indication) the format of the unsolicited indication depends
on the specific command:

if =1 (REFRESH)

an unsolicited notification will be sent to the user:

#STN: ,

where:

0 - SIM Initialization and Full File Change Notification;