Rainbow Electronics GM862-QUAD-PY - Manual (Page 209)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 209 of 434
+CMGR - Read Message SELINT 2
- Destination address, string type represented in the currently
selected character set (see +CSCS)
- string type alphanumeric representation of or ,
corresponding to an entry found in the phonebook; used
character set is the one selected with command +CSCS.
- Service Centre number
,, - type of number ,,
129 - number in national format
145 - number in international format (contains the "+")
- text length
- TP-User_data
• If indicates that GSM03.38 default alphabet is used , each
character of GSM alphabet will be converted into current TE
character set (see +CSCS)
• If indicates that 8-bit or UCS2 data coding scheme is
used, each 8-bit octet will be converted into two IRA character
long hexadecimal number (e.g. octet 0x2A will be converted as
two characters 0x32 0x41)
Note: in both cases if status of the message is 'received unread',
status in the storage changes to 'received read'.
Note: an error result code is sent on empty record .
AT+CMGR=? Test command returns the OK result code
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
Reference GSM 07.05
(#SMSMODE=1)
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
AT+CMGR=
Execution command reports the message with location value
from message storage ( is the message storage for
read and delete SMs as last settings of command +CPMS).
Parameter:
- message index.
The output depends on the last settings of command +CMGF
(message format to be used)
(PDU Mode)
If there is a message in location , the output has the
following format:
+CMGR: ,,
where
- status of the message
0 - new message