Rainbow Electronics GM862-QUAD-PY - Manual (Page 93)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 93 of 434
+CLIP - Calling Line Identification Presentation SELINT 0 / 1
0 - CLI valid
1 - CLI has been withheld by the originator.
2 - CLI is not available due to interworking problems or limitation or
originating network.
Note: in the +CLIP: response they are currently not reported either the
subaddress information (it’s always “” after the 2
nd comma) and the
subaddress type information (it’s always 128 after the 3 rd comma)
Note: issuing AT+CLIP is the same as issuing the Read command.
Note: issuing AT+CLIP= is the same as issuing the command
AT+CLIP=0.
AT+CLIP? Read command returns the presentation status of the CLI in the format:
+CLIP: ,
where:
0 - CLI presentation disabled
1 - CLI presentation enabled
- status of the CLIP service on the GSM network
0 - CLIP not provisioned
1 - CLIP provisioned
2 - unknown (e.g. no network is present )
Note: This command issues a status request to the network, hence it may
take a few seconds to give the answer due to the time needed to exchange
data with it.
AT+CLIP=? Test command returns the supported values of the parameter
Reference GSM 07.07
Note The command changes only the report behaviour of the device, it does not
change CLI supplementary service setting on the network.
+CLIP - Calling Line Identification Presentation
SELINT 2
AT+CLIP=[] Set command enables/disables the presentation of the CLI (Calling Line
Identity) at the TE. This command refers to the GSM supplementary service
CLIP (Calling Line Identification Presentation) that enables a called
subscriber to get the CLI of the calling party when receiving a mobile
terminated call.
Parameters: