Rainbow Electronics GM862-QUAD-PY - Manual (Page 191)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 191 of 434
+CNMI - New Message Indications To Terminal Equipment SELINT 2
(TEXT Mode)
+CDS: ,,,,,
- message reference number; GSM 03.40 TP-Message-
Reference in integer format
- arrival time of the message to the SC
2 - if a status report is stored, then the following unsolicited result
code is sent:
+CDSI: ,
where:
- memory storage where the new message is stored
"SM"
- location on the memory where SMS is stored
- buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command
is flushed to the TE when =1..3 is entered (OK response
shall be given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command
is cleared when =1..3 is entered.
AT+CNMI? Read command returns the current parameter settings for +CNMI
command in the form:
+CNMI: ,,,,
AT+CNMI=? Test command reports the supported range of values for the +CNMI
command parameters.
Reference GSM 07.05
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
Note DTR signal is ignored, hence the indication is sent even if the DTE is
inactive ( DTR signal is Low). In this case the unsolicited result code
may be lost so if MODULE remains active while DTE is not, at DTE
startup is suggested to check whether new messages have reached
the device meanwhile with command AT+CMGL=0 that lists the new
messages received.
(#SMSMODE=1)
#
S
M
S
M
O
AT+CNMI=[
[,
[,[,
[,]]]]] Set command selects the behaviour of the device on how the
receiving of new messages from the network is indicated to the DTE.
Parameter:
- unsolicited result codes buffering option
0 - Buffer unsolicited result codes in the TA. If TA result code buffer