Rainbow Electronics GM862-QUAD-PY User Manual
Page 115

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 115 of 434
+CPIN - Enter PIN
SELINT 0 / 1
If the PIN required is SIM PUK or SIM PUK2, the
This second pin,
The command may be used to change the SIM PIN by sending it with both
parameters
request is pending the command will return an error code and to change the
PIN the command +CPWD must be used instead.
Parameters:
To check the status of the PIN request use the command AT+CPIN?
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command.
AT+CPIN?
Read command reports the PIN/PUK/PUK2 request status of the device in
the form:
+CPIN:
where: - PIN/PUK/PUK2 request status code
READY - ME is not pending for any password
SIM PIN - ME is waiting SIM PIN to be given
SIM PUK - ME is waiting SIM PUK to be given
PH-SIM PIN - ME is waiting phone-to-SIM card password to be given
PH-FSIM PIN - ME is waiting phone-to-very first SIM card password to be
given
PH-FSIM PUK - ME is waiting phone-to-very first SIM card unblocking
password to be given
SIM PIN2 - ME is waiting SIM PIN2 to be given; this is returned
only when the last executed command resulted in PIN2
authentication failure (i.e. +CME ERROR: 17)
SIM PUK2 - ME is waiting SIM PUK2 to be given; this is returned
only when the last executed command resulted in PUK2
authentication failure (i.e. +CME ERROR: 18)
PH-NET PIN - ME is waiting network personalization password to be given
PH-NET PUK - ME is waiting network personalization unblocking
password to be given
PH-NETSUB PIN - ME is waiting network subset personalization password
to be given
PH-NETSUB PUK - ME is waiting network subset personalization
unblocking password to be given
PH-SP PIN - ME is waiting service provider personalization password to
be given
PH-SP PUK - ME is waiting service provider personalization unblocking
password to be given
PH-CORP PIN - ME is waiting corporate personalization password to be