Rainbow Electronics GM862-QUAD-PY - Manual (Page 218)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 218 of 434
+CMGS - Send Message SELINT 2
If message is successfully sent to the network, then the result is sent
in the format:
+CMGS:
where
- message reference number; GSM 03.40 TP-Message-
Reference in integer format.
Note: if message sending fails for some reason, an error code is
reported.
Note: care must be taken to ensure that during the command
execution, which may take several seconds, no other SIM interacting
commands are issued.
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
#
S
M
S
M
O
D
E
=
0
(Text Mode)
AT+CMGS=
[,] (Text Mode)
Execution command sends to the network a message.
Parameters:
- destination address, string type represented in the currently
selected character set (see +CSCS).
- type of destination address
129 - number in national format
145 - number in international format (contains the "+")
After command line is terminated with , the device responds
sending a four character sequence prompt:
(IRA 13, 10, 62, 32)
After this prompt text can be entered; the entered text should be
formatted as follows:
- if current (see +CSMP) indicates that GSM03.38 default
alphabet is used and current (see +CSMP) indicates that GSM
03.40 TP-User-Data-Header-Indication is not set, then ME/TA
converts the entered text into GSM alphabet, according to GSM
07.05, Annex A; backspace can be used to delete last character
and carriage returns can be used.
- if current (see +CSMP) indicates that 8-bit or UCS2 data
coding scheme is used or current (see +CSMP) indicates that
GSM 03.40 TP-User-Data-Header-Indication is set, the entered text
should consist of two IRA character long hexadecimal numbers
which ME/TA converts into 8-bit octet (e.g. the ‘asterisk’ will be
entered as 2A (IRA50 and IRA65) and this will be converted to an
octet with integer value 0x2A)