Rainbow Electronics GM862-QUAD-PY - Manual (Page 85)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 85 of 434
+COPS - Operator Selection SELINT 0 / 1
Note: issuing AT+COPS is the same as issuing the Read command.
Note: issuing AT+COPS= is the same as issuing the command
AT+COPS=0.
AT+COPS? Read command returns current value of , and in
format ; if no operator is selected, and are
omitted
+COPS: [, , ]
AT+COPS=? Test command returns a list of quadruplets, each representing an operator
present in the network.
The behaviour of Test command depends on the last #COPSMODE setting.
(#COPSMODE=0)
The command outputs as many rows as the number of quadruplets, each of
them in the format:
+COPS: ( ,=0)>,””,
=2)>)
where
- operator availability
0 - unknown
1 - available
2 - current
3 - forbidden
(#COPSMODE=1)
The quadruplets in the list are separated by commas:
+COPS: [list of supported ( ,=0)>,,
=2)> )s][,,(list of supported s),
(list of supporteds)]
where
- operator availability
0 - unknown
1 - available
2 - current
3 - forbidden
Note: since with this command a network scan is done, this command may
require some seconds before the output is given.
Note: The value of parameter (in =0) is the same as the